Team Losi XXX-NT AD2 Owner's Manual page 24

Step E-11 Step E-11
Step E-11 Step E-11 Step E-11
Left Gear Box Bearing Install:
80
1. Use the short, 4-40 Thread-Cutting Screw, included in the wrench
bag, to pre-tap the three holes noted in Figure E-11. Thread the Screw
all the way into and out of each hole on the Left Gearbox Half (83).
2. Insert two 3/16" x 3/8" sealed Bearing (80) into the two top
bearing seats of the left Gearbox Half.
3. Insert a 1/2" x 3/4" Bearings (81) into the lower Bearing seat of
the left Gearbox Half.
Step E-12 Step E-12
Step E-12 Step E-12 Step E-12
Diff and Top Shaft Install:
1. Insert the Top Shaft (73) into the forward-most Bearing (80) in
the left Gearbox Half (83).
*NOTE: be sure the head of the Diff Adjusting Screw faces the
right side of the Gearbox Half. This will allow easy adjustment
while running your truck.
2. Insert the Differential assembly into the 1/2" x 3/4" Bearing
(81) in the left Gearbox Half. Insert the Diff Nut (57) side first.
B B B B B A A A A A G E (Contin G E (Contin G E (Contin
G E (Contin ued)
G E (Contin
81
ued) ued)
ued)
ued)
83
83
81
64
20
PRE-TAP
THESE HOLES
80
81
Figure E-11
80
Figure E-12
73