Team Losi XXX-NT AD2 Owner's Manual page 39

Step H-4 Step H-4
Step H-4 Step H-4 Step H-4
Clutch Shoe Install:
IMPORTANT NOTE: Make sure that the Clutch Shoes are fac-
ing the correct direction as illustrated, when the motor has been in-
stalled. Position the Clutch so that the shoes are separated one on
top, one on bottom. The top Clutch Shoe should be attached to the
Pin at the left side of the Flywheel, as shown in Figure H-4, when
looking at the engine from the front.
1. Slide the Clutch Shoe assembly over the Clutch Nut (155).
Place each Clutch Shoe (157) over a Clutch Pin (151) and slide the
Shoes all the way against the Flywheel (152). In order for the Shoes to
slide over the Clutch Nut, they will have to be pulled apart slightly,
stretching the Clutch Springs (156).
Step H-5 Step H-5 Step H-5
Step H-5 Step H-5
Clutch Bell Install:
158
1. Insert a 1/4" x 3/8" Clutch Bearing (158) into each side of the
Clutch Bell (159).
2. Slide the Clutch Bell over the Clutch Nut (151) so that the gear
faces out. Push the Clutch Bell all the way against the clutch assem-
bly.
3. Place the Clutch Spacer (160) over the Clutch Nut and against
the Clutch Bell. Secure the assembly by spreading the 1/4" Snap Ring
(161) over the end of the Clutch Nut and into the groove in the Clutch
Nut.
IMPORTANT NOTE: The Bearings used in the clutch contain a
special grease that does not migrate. It is important that these bear-
ings only be replaced with Team Losi's replacement clutch bearings.
It is also important not to oil the bearings in the clutch. Any oil that is
put on the bearings can find its way into the clutch assembly and
cause the clutch to slip.
Ba Ba g H g H
Ba g H g H
Ba Ba g H
160 161
(Contin ued) (Contin (Contin ued) ued) ued)
(Contin (Contin ued)
157
159
160
161
35
155
151
156
Figure H-4
155
158
158
Figure H-5
152