Team Losi XXX-NT AD2 Owner's Manual page 35

Step F-7 Step F-7
Step F-7 Step F-7 Step F-7
Rear Shock Install:
31 95
1. Make sure that the Cross Bones (107) are in the Outdrives
(60)(66) before continuing.
2. Insert a 4-40x 1/2" Cap-Head Screw (31) through the Shock
Mount Ball (121) in one of the rear Shocks. Position the bottom of the
Shock, with the Screw, behind the the Shock mounting area on the left
rear Suspension Arm (118). Thread the Screw all the way into the
second hole, on the top row, from the inside on the rear Arm, as
shown.
3. Slide a short Shock Mount Bushing (142), large side first, over
the uppper shock mounting Screw (33) on the left side of the rear
Shock Tower.
*NOTE: Before attaching the top of the Shock, make sure that the
Dogbone is in place in the Outdrive.
4. Place the top of the Shock Body (138) over the Shock Mount
Bushing on the Rear Shock Tower (123) and secure it with a 4-40
Locknut (95).
5. Repeat Steps 1-4 for the right rear Shock.
Step F-8 Step F-8 Step F-8 Step F-8 Step F-8
Front Shock Install:
31
1. Insert the Shock End (133) of a front Shock between the shock
mounting rails of the front suspension Arm (48) and line up the hole
in the Shock Mount Ball (121) with the middle hole in the Arm.
2. Attach the Shock End to the front Arm by threading a 4-40 x
1/2" Cap-Head Screw (31) all the way into the Arm.
3. Slide a long Shock Mount Bushing (143), large side first, over
the Screw (33) on the left side of the Front Shock Tower (34).
4. Place the top of the Shock Body (137) over the Shock Mount
Bushing on the front Shock Tower and secure it with a 4-40 Locknut
(95).
5. Repeat Steps 1-4 for the right front Shock.
B B B B B A A A A A G F (Contin G F (Contin G F (Contin
G F (Contin ued)
G F (Contin
142
143
95
ued) ued)
ued)
ued)
107
48
133
31
138
142
33
31
121
118
Figure F-7
137
95
31
Figure F-8
95
143