Team Losi XXX-NT AD2 Owner's Manual page 27

Step E-16 Step E-16
Step E-16 Step E-16 Step E-16
Brake Hub Install:
27 96
1. Press the 2mm x 8mm Solid Pin (120) into the hole in the end of
the Brake Shaft (77) so that it extends evenly from both sides of the
Shaft.
2. Slide the Brake Hub (98) over the Brake Shaft. Align the groove
in the Brake Hub with the Pin and slide the Hub over the Pin.
3. Use the short, 4-40 Thread-Cutting Screw, included in the wrench
bag, to pre-tap the three holes shown in Figure E-16.
4. Thread the two 4-40 x 5/8" Set Screws (27) all the way into each
of the two Brake Caliper mounting holes in the left Gearbox Half (83).
5. Slip a 1/4" x .020 Washer (96) and a Brake Sleeve (97) over each
of the two 4-40 x 5/8" Set Screws.
Step E-17 Step E-17
Step E-17 Step E-17 Step E-17
Brake Caliper Install:
1. Place one of the Brake Caliper Plates (99) so the ears of the
Caliper rest against the Washers and inbetween the two Brake Sleeves
(97).
2. Slide the Brake Rotor (100) onto the Brake Hub (98).
3. Place the other Brake Caliper Plate inbetween the Brake Sleeves.
B B B B B A A A A A G E (Contin G E (Contin G E (Contin
G E (Contin ued)
G E (Contin
120
97
ued) ued)
ued)
ued)
120
Pre-Tap
These Holes
83
23
77
27
27
96
Figure E-16
97
99
97
98
Figure E-17
96
97
98
97
99
100