Team Losi XXX-NT AD2 Owner's Manual page 28

Step E-18 Step E-18
Step E-18 Step E-18 Step E-18
Brake Lever Assembly:
95 96
1. Place a 1/4" x .020 Washer (96) over each of the two 4-40 x 5/8"
Set Screws (27) against the Brake Sleeve.
2. Hold the Brake Lever Clips (101) in position on the Brake Lever
(102), slide the Brake Lever Clips over the 4-40 x 5/8" Set-Screws.
IMPORTANT NOTE:Be sure the top Brake Lever Clip points
towards the front of the Gearbox and the lower Brake Lever Clip points
towards the rear.
3. Secure the Brake Lever Clips with two 4-40 steel Locknuts (95).
Tighten the Nuts until they are just snug, then back them off about
1/8 -1/4 turn, so the Brake Lever Clips are slightly loose.
4. Insert a 3/16" E-clip (103) into the groove in the end of the
Brake Shaft (77) to retain the Brake Hub (98).
Step E-19 Step E-19 Step E-19 Step E-19 Step E-19
Gear Box Install:
17
1. Place the Gearbox assembly onto the rear of the Chassis (19),
align the bottom for the Gearbox Halves (82)(83) with the rectangular
hole in the Chassis. The bottom of the Gearbox should be flush with
the bottom of the Chassis.
2. Attach the Gearbox assembly to the rear of the Chassis with
four 4-40 x 3/8" Flat-Head Screws (20)
3. Secure the Gearbox Brace (88) to the Chassis Brace (29) with
two 4-40 x 3/8" Cap-Head Screws (17).
B B B B B A A A A A G E (Contin G E (Contin G E (Contin
G E (Contin ued)
G E (Contin
103
20
ued) ued)
ued)
ued)
Figure E-18
17
29
19
Figure E-19
24
103
102
77
96
101
88
95
20