Team Losi XXX-NT AD2 Owner's Manual page 14

Step C-8 Step C-8
Step C-8 Step C-8 Step C-8
Tank Grommet Install:
28
1. Press a rubber Tank-Mounting Grommet (28) into each of the
three large holes in the top of the Chassis Brace (29) as shown. The
chassis brace should seat into the grove on the outside of the Grom-
met.
Step C-9 Step C-9
Step C-9 Step C-9 Step C-9
Tank Install:
17
1. Line up the three posts on the Fuel Tank (30) with the three
holes with Grommets in the Chassis Brace (29). Install the Fuel Tank
on the Chassis Brace from the bottom by pressing the three Posts on
the Tank through the three Rubber Grommets (28).
IMPORTANT NOTE: Push around the outer edges of the Fuel
Tank while pressing the Tank into the Grommets. This will prevent
cracking the seal around the bottom of the tank.
The Screws should not be tightened so that Grommet
smashes. By tightening the Screws until the washers just touch the
Grommets, the tank will be "shock mounted". This helps the fuel
from foaming while the truck running.
2. Place a #4 Washer (23) over each of the three 4-40 x 3/8" Cap-
Head Screws (17). Thread a Screw through each of the Grommets and
into the posts in the Fuel Tank. Hold the Tank all the way up against
the Chassis Brace. Tighten each of the three Screws (14) until the
Washer just touches the Grommet.
Step C-10 Step C-10 Step C-10 Step C-10 Step C-10
Fuel Line Clip Install:
20
1.Attach the Fuel Line Clip (84) to the Chassis (19) by placing a
4-40 x 3/8" Flat-Head Screw (20) into the through hole in the Chassis
and thread the screw into the Fuel Line Clip, hold the Clip so it re-
mains parallel with the sides of the chassis and tighten.
*NOTE: The clip should run parallel with the length of the Chassis.
B B B B B A A A A A G C (Contin G C (Contin G C (Contin
G C (Contin ued)
G C (Contin
23
ued) ued)
ued)
ued)
Figure C-8
17
23
29
30
Figure C-10
11
28
29
28
Figure C-9
84
20
19