Table of Contents
Advertisement
Transceiver Connections
Control Head Mounting Trunnion Installation
22
Remote Mounting
1.
Connect the transceiver-to-junction box cable to the accessory connector.
2.
After mounting the antenna, run the antenna coaxial cable to the transceiver
mounting location. If necessary, cut off the excess cable.
3.
Connect the antenna cable connector to the antenna BNC connector at the rear of the
transceiver (see Figure 21). Ensure that the antenna's cable connector is fully
tightened. DO NOT use an adaptor between the antenna cable connector and the
transceiver.
4.
Install the power cable as explained on page 25. Cut the power supply cable to the
desired length and plug the power cable into the transceiver power connector (see
Figure 21).
Accessory
Connector (not visible)
1.
Using the control head trunnion as a template, mark the positions of the holes on the
mounting surface.
2.
Centerpunch the spots you have marked and drill a 4 mm Ø (0.16 inch) hole at each
mark.
3.
Secure the trunnion mounting bracket with the four screws supplied. See Figure 22
below and Table 3 for figure callouts.
1
Figure 22 Control Head Mounting Trunnion
Antenna
Connector (BNC)
Figure 21 Connections to Radio
2
3
4
Vehicle Chassis Ground
(Black)
Power Connector
To Battery+
via Fuse (F1)
(Red)
Hide quick links:
Advertisement
Table of Contents
