Installing and Connecting the MTM300
Transceiver Trunnion Installation
Transceiver Installation
1.
Using the trunnion bracket as a template, mark the positions of the holes on the
mounting surface (see Figure 20). Use the innermost four holes for a curved
mounting surface, and use the four outmost holes for a flat surface.
2.
Centerpunch the spots you have marked and drill a 4 mm Ø hole at each mark.
3.
Secure the trunnion mounting bracket with the four screws provided.
1.
Ensure that the plastic guides are aligned (horizontal) to the transceiver grooves.
2.
Slide the transceiver grooves into the plastic guides until it snaps into place.
3.
Secure the transceiver with the two wing screws provided.
Wing Screw
Figure 20 Transceiver Trunnion Mounting
Trunnion
Groove
Thread Hole for
Wing Screw
Plastic Guides
Tabs
Wing Screw
Mounting Surface
Remote Mounting
21