Download Print this page

Motorola Dimetra MTM300 Installation Instructions Manual: Figure 56 Connection Plan For Ignition Sense Cable

Hide thumbs

Advertisement

reset and, therefore, turn off, during vehicle cranking, if the vehicle battery voltage drops
below a certain level.
The ignition sense cable kit contains a thin cable and a fuse holder. To install the cable,
carry out the following steps.
1.
Connect the stripped lead of the fuse holder cable only to an ignition switched
terminal of the fuse block. Use the supplied terminal or any other suitable terminal.
2.
Mount the fuse holder using the mounting hole, and dress wires as required.
3.
Cut the thin cable to the required length, crimp the supplied red lead to the stripped
lead of the thin cable, and connect it to the blue terminal of the fuse holder cable.
4.
Connect the other end of the ignition sense thin cable to pin 4 of the junction box
terminal.
5.
Insert the provided fuse into the fuse holder and close the cover.
JUNCTION BOX TERMINAL

Figure 56 Connection Plan for Ignition Sense Cable

TO IGNITION
SWITCH
IGNITION
SENSE
CABLE
SWITCHED BATTERY VOLTAGE
Motorcycle Installation
49

Advertisement

   Related Manuals for Motorola Dimetra MTM300

Comments to this Manuals

Symbols: 0
Latest comments: