Table of Contents
Advertisement
Optional HLN6372 Keylock Installation
9.
Install the power cable (see page 12). Cut the power supply cable to the desired
length and plug the power cable into the radio power connector (see Figure 8).
10. Route other accessory wires to appropriate locations in the vehicle and connect them
to their respective accessories. (For connecting the ignition sense cable, refer to
page 18.)
11. Mount the microphone clip to a convenient spot near the radio.
12. Plug the microphone into the connector on the radio front panel.
13. Attach the S-hook and crimp (on microphone cable) to the hole on the radio
trunnion.
To install optional Keylock HLN6372 (see Figure 9), proceed as follows:
1.
Place the two keylocks on each side of the mounting trunnion to cover the two wing
screws holding the radio.
2.
Secure the keylocks with the lock key.
Key
Figure 9 Optional Keylock Installation
To Battery+
via Fuse (F1)
(Red)
Antenna
Connector (BNC)
Figure 8 Connections to Radio
Wing Screw
Keylock
HLN6372
Lock
Vehicle Chassis Ground
(Black)
Power Connector
Mounting
Trunnion
Dash Mounting
11
Hide quick links:
Advertisement
Table of Contents
