Programming Reference - AT&T Partner II Installation And Use Manual

Next Procedure/
Prev Procedure
Cycle forward/backward
through the programming
procedures. You can use
these buttons to select a
procedure.
Enter
Ends an entry of
variable length,
such as a
telephone number
in an Allowed
Phone Number List.
System Program
(Intercom)
Starts the System
Programming
process.
Feature
When followed by
[ ][ ], enters or exits
0 0
programming mode.
AT&T
518-455-321
Figure 5-1. Programming Overlay for MLS-34D Phone
Next Item/Prev Item
Cycles forward/backward
through a procedure's
parameters. A parameter
is typically a line, an extension,
or a telephone list entry. If a
procedure has two parameters
(for example, a line and
extension) Next Item/Prev Item
affects only the second one.
Next
Procedure
Prev
Procedure
Feature
Wild
Next Data/Prev Data
Cycle forward/backward
through the valid data entries.
These buttons work only for
fixed data, such as a line or
extension jack number. They
do not work for variable data
such as date, time, password,
telephone numbers, or
doorphone assignments.
Next Next
Item
Data
Prev Prev
Item Data
Central Tel Program
(Intercom)
Starts the Centralized Telephone
Programming process (that is,
customizing individual telephones
remotely from the phone at
extension jack 10 or 11).
Wild
Enters a "wildcard" (a character
that matches any digit dialed)
in telephone numbers in Allowed
and Disallowed Phone Number
Lists.
NOTE:
This is a full-size illustration. If you lose the original, you can
order a replacement by calling 1 800 432-6600 in the U.S. or
1 800 255-1242 in Canada. The order number is 518-455-321.
Remove
Returns the current setting
to the factory setting.
Remove
Enter
PARTNER™ Plus/
II Communications Systems
Programming Overlay for MLS-34D Telephones
PARTNER Plus: Use at Ext. 10 only
PARTNER II: Use at E t 10 or 11 only
X
System Central
Tel Program
Program

Programming Reference

5-5