Advertisement
FT1000 ASSEMBLY INSTRUCTIONS
WEIGHT STACK ASSEMBLY
K. Place one weight stack cushion on each Guide Rod and slide down to the
base. Apply lubricant to the Guide Rods from the weight stack cushions to
the tops of the Guide Rods.
Making sure that the recess for the weight labels is facing inside the machine
and that the three pads are facing down, slide onto the Guide Rods: 10 – 10lb.
Weights and then 10 - 5lb. Weights (standard 150lb. weight stacks – optional
stacks have their own configuration). Place the Top Weight and Cable on the
Guide Rods with the drilled hole facing the machine and slide down to the
stack.
Stand the weight stack and guide rods back up and thread the 3/8" bolts down
into the guide rods to secure.
STEP L. AND M. ARE FOR THE 4:1 OPTION ONLY
L. Place one weight stack cushion on each Guide Rod and slide down to the
base. Apply lubricant to the Guide Rods from the weight stack cushions to
the tops of the Guide Rods.
Making sure that the recess for the weight labels is facing inside the machine
and that the three pads are facing down, slide onto the Guide Rods: 10 – 10lb.
Weights and then 10 - 5lb. Weights (standard 150lb. weight stacks – optional
stacks have their own configuration). Place the Top Weight and Cable on the
Guide Rods with the drilled hole facing the machine and slide down to the
stack. Leave enough cable slack for the Upper Bracket.
Stand the weight stack and guide rods back up and thread the 3/8" bolts down
into the guide rods to secure.
M. Install the Upper Pulley Brackets between the guide rods, below the square
tube using two 3/8" x 2 ½" bolts, four flat washers and two locknuts for each
side.
AT THIS TIME IT IS RECOMMENDED TO CHECK:
Are the loop ends of the cables to the inside of the machine?
Are the threaded ends of the cables to the outside of the machine?
Are the Upper Brackets oriented so that the cables do not cross the path of
the weight stack? (4:1 option only)
8
Advertisement
