Table of Contents
Advertisement
M
EMORY
Before beginning the Memory Storage operation, select the desired frequency while oper-
ating in the "Main" band VFO. Be sure to set up any desired CTCSS or DCS tones, as well
as any repeater offset. The power level setting is also stored in the memory.
Press and hold in the [ V/M ] key for two seconds to display the "Memory Edit" window.
If you wish to append an Alpha/numeric "Tag" to this channel, press and hold the
[ V/M ] key again. Then enter the desired name "Tag" (up to 8 characters) one of the
methods shown in the following examples. Otherwise, skip to the next step.
Example 1: Enter the characters/numbers by pressing the microphone keypad buttons;
or use the microphone [ UP ] / [ DWN ] keys to select them. Press the [ B ]
key to move the cursor to the next digit. Press the [ A ] key to backspace the
cursor, and press the [ C ] key to delete all data after the cursor. You may
change the character (uppercase, lowercase, numeric, or symbol) by press-
ing the [ ] key.
Example 2: Rotate the left side [ DIAL ] knob to select a character/number and press
the [
backspace the cursor. You may change the character (capital, small, nu-
meric, or symbol) by pressing the [ FONT ] key.
Press the [ V/M ] key to store the frequency and settings into memory.
On rare occasions the stored data may become corrupted by miss operation, or
static electricity. When repairs are made, the memory data may be lost. Please
write down or record the memory information so you will be able to restore it if
needed.
6
O
PERATION
M
EMORY
] key to move the cursor to the next digit. Press the [ BS ] key to
Impotant Note
S
TORAGE
FTM-350AR/AE O
M
PERATING
ANUAL
Advertisement
Table of Contents
