Table of Contents
Advertisement
S
PECIAL
Static electricity may occasionally cause erratic or unpredictable operation of the micropro-
cessor. If this happens, resetting of the microprocessor may restore normal operation. Note
that resetting the microprocessor will erase all memories.
1. Turn the radio "off".
2. Turn the radio on while pressing and holding the key which is located to the left of the
[ POWER ] switch to enter the "Special Function" mode.
3. Rotate the left side [ DIAL ] knob to select one of the following items:
1 CLONE RX: Uses this item for transceiver cloning. See the next page for details.
2 CLONE TX: Uses this item for transceiver cloning. See the next page for details.
3 L-MEMORY SORT:
4 R-MEMORY SORT:
5 SYSTEM RESET:
6 ALL RESET:
7 APRS RESET:
8 BAND SCOPE:
9 B-T PAIRING:
10 GPS DATUM:
11 XBAND REPEATER: Activates Cross Band Repeater operation. Set the right band
4. Once you have made your selection in step 3, press the left side [ DIAL ] knob and
confirm that ( OK? [ SET ]) is displayed on the LCD. Press the left side [ DIAL ] knob
once more to complete the reset procedure. (To cancel the reset procedure, press the
[ ESC ] key before pressing the left side [ DIAL ] knob.)
52
F
UNCTION
Sorts and renumbers the memory channels of the left side
memory bank by frequency, from low to high. See page 10
for details.
Sorts and renumbers the memory channels of the right side
memory bank by frequency, from low to high. See page 10
for details.
Resets the Set Mode item settings (except "APRS/PKT"
group) to their factory defaults.
Clears all memories and other settings to factory defaults.
Resets only the Set Mode item setting of the "APRS/PKT"
group to their factory defaults.
Switches the Band Scope operation to the Enhanced Mode.
See page 13 for details.
Set up the Bluetooth
Select the GPS datum to be used.
to a 144 MHz frequency and the left band to a 430MHz
frequency (or vice versa) before beginning this procedure.
M
ENU
device. See page 18 for details.
®
FTM-350AR/AE O
M
PERATING
ANUAL
Advertisement
Table of Contents
