Table of Contents
Advertisement
The FTM-350 Series Transceiver includes a convenient "Clone" feature, which allows the
memory and configuration data from one transceiver to be transferred to another FTM-350
Series Transceiver. This can be particularly useful when configuring a number of transceiv-
ers for a public service operation. Here is the procedure for Cloning one radio's data to
another:
1. Turn both radios "off".
2. Connect the optional CT-135 Clone Cable between the DATA jacks of the two radios.
3. Turn the radio on while pressing and holding the key which is located to the left of the
[ POWER ] switch to enter the "Special Function" mode. Do this for both radios (the
order of switch-on does not matter).
4. On the "Destination" radio, rotate the left side [ DIAL ] knob to select function menu
item "1 CLONE RX", then press the left side [ DIAL ] knob twice.
5. On the "Source" radio, rotate the left side [ DIAL ] knob to select function menu item
"2 CLONE TX", then press the left side [ DIAL ] knob. The data from this radio will be
transferred to the other radio.
6. If there is a problem during the cloning process, "ERROR" will be displayed. Check
your cable connections and battery voltage, and try again.
7. If the data transfer is successful, the "Destination" radio displays "RECEIVED...."
then turns "off" automatically and turns "on" again.
8. Press the [ DIAL ] key of the "Source" radio. The "Source" radio will now automatically
turn "off" and turn back "on" again.
9. Turn both radios "off" and disconnect the Clone Cable.
Can not perform the cloning operation between the FTM-350AR and FTM-350AE.
FTM-350AR/AE O
M
PERATING
ANUAL
C
LONING
49
Advertisement
Table of Contents
