Table of Contents
Advertisement
N
O
AVI
PERATION
The FTM-350 Series Transceiver enables navigating to any destination previously entered
into the "Point" memory. Furthermore, you may enable navigating to the location of an-
other APRS station by using the APRS feature. See page 32 in the APRS manual for details.
Before beginning Navigation, the "NAVI" page must be enabled via Set Mode item "C01
DISPLAY SELECT" in the "DISPLAY" group. See page 37.
Press the [ FWD ] or [ BCK ] key repeatedly, until the "NAVI" Page appears.
Press the [ PLIST ] key to open the "Point" memory list, then rotate the left side [ DIAL ]
knob to select the desired destination.
Press the [ NAVI ] key to return to the "NAVI" Page. The destination appears at the
upper right of the display, and the distance between your current position and destina-
tion appears at the lower right of the display. Additionally, your course direction (com-
pass) is shown in the left half of the display.
Press the [ NAVI ] key to initiate navigation. Drive your vehicle so that the "CAR" icon
turns to a "D" symbol in the Compass display.
If desired, while navigating, the current position and date may be stored into the "Point"
memory by pressing the [ POINT ] key. Four groups of "Point" memories are available
with four channels for each group.
When your vehicle nears the destination, emits the alarm beep and the "GOAL!" notation
appears in the Compass display.
To return to the "Radio" page, press the [ FWD ] or [ BCK ] key repeatedly, until the "Radio"
Page appears.
You may customize the NAVI operation via the "NAVI" group of the Set Mode (see page
43).
28
( R
O
EQUIRES
PTIONAL
FTM-350AR/AE O
GPS A
U
NTENNA
M
PERATING
ANUAL
)
NIT
Advertisement
Table of Contents
