Diamond DA 40 Flight Manual page 112

Emergency
Procedures
(c) Starter Malfunction
If the starter does not disengage from the engine after starting (starter warning light
(START) on the annunciator panel remains illuminated or flashing after the engine has
started):
1. Throttle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . IDLE
2. Mixture control lever . . . . . . . . . . . . . . . . . . LEAN - shut off engine
3. Ignition switch . . . . . . . . . . . . . . . . . . . . . . . OFF
%
4. Master switch (ALT/BAT) . . . . . . . . . . . . . . OFF
Terminate flight preparation!
END OF CHECKLIST
(d) Overvoltage
If a voltage in the upper red sector (above 32 Volts) is indicated:
1. Essential bus . . . . . . . . . . . . . . . . . . . . . . . . ON, if installed
2. Master switch (ALT) . . . . . . . . . . . . . . . . . . . OFF
3. Equipment that is not needed,
in particular Pitot heating . . . . . . . . . . . . . . . OFF
4. Land on the nearest appropriate airfield.
END OF CHECKLIST
Page 3 - 38
WARNING
Leave Master switch (BAT) ON!
Rev. 8 01-Dec-2010
DA 40 AFM
Doc. # 6.01.01-E