Display Panel - HP ProOne 400 G1 Maintenance & Service Manual

Display panel

NOTE: You MUST remove and replace all parts that come in the kit.
NOTE:
Do not reuse any old parts. Return all old parts to HP for warranty processing.
Display panels are available from two different manufacturers — SOC and BOE.
Display panels require a backlight cable specific to the manufacturer. Make sure you use the backlight
cable packaged with the display panel.
The display panel is secured to the base pan with four Torx screws.
To remove the display panel:
1.
Prepare the computer for disassembly (see
2.
Remove the rear cover (see
3.
Remove the webcam (see
4.
Remove the bottom stand (see
5.
Remove the front bezel (see
78 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis
Preparing to disassemble the computer on page
Rear cover on page 30).
Webcam module on page
Bottom stand on page
Front bezel on page 50).
43).
48).
27).