HP ProOne 400 G1 Maintenance & Service Manual page 91

9.
Remove the brackets from the display by removing the two Torx screws from each side, and then
lifting the brackets from the display.
NOTE:
The image below shows screws on only one side. Screw locations are similar on both
sides.
NOTE: You must remove and reuse the display brackets when you replace the panel.
10.
Be sure to correctly position the jumpers on the converter board based on the manufacturer of the
installed display panel. Jumper settings are printed on the converter board.
CAUTION: Incorrect jumper placement can result in damage to the converter board and display
panel.
Display panels are available from two manufacturers that require the following jumper placement.
SOC panel: pins (1)(2), (3)(4)
●
BOE panel: pins (7)(8), (9)(10)
●
To install a display panel, reverse the removal procedures.
NOTE: You MUST remove and replace all parts that come in the kit.
NOTE:
Do not reuse any old parts. Return all old parts to HP for warranty processing.
NOTE: You must remove and reuse the display brackets when you replace the panel.
Display panel
81