Heat Sink - HP ProOne 400 G1 Maintenance & Service Manual

Heat sink

The heat sink is located near the middle of the computer and is secured with four captive Torx screws
and one non-captive Torx screw. You do not have to remove the heat sink to remove the fan.
To remove the heat sink:
1.
Prepare the computer for disassembly (see
2. Remove the rear cover (see
3. Remove the VESA panel (see
4. Remove the system board shield (see
5. Remove the non-captive Torx screw from the end of the heat sink (1).
Preparing to disassemble the computer on page
Rear cover on page 30).
VESA panel on page
System board shield on page
55).
56).
27).
Heat sink
65