Password Security And Resetting Cmos - HP ProOne 400 G1 Maintenance & Service Manual

11 Password Security and Resetting
CMOS
This computer supports security password features, which can be established through the Computer
Setup Utilities menu.
This computer supports two security password features that are established through the Computer Setup
Utilities menu: setup password and power-on password. When you establish only a setup password,
any user can access all the information on the computer except Computer Setup. When you establish
only a power-on password, the power-on password is required to access Computer Setup and any
other information on the computer. When you establish both passwords, only the setup password will
give you access to Computer Setup.
When both passwords are set, the setup password can also be used in place of the power-on
password as an override to log in to the computer. This is a useful feature for a network administrator.
If you forget the password for the computer, you can clear that password so you can gain access to the
information on the computer by resetting the password jumper.
CAUTION:
back up the computer CMOS settings before resetting them in case they are needed later. Back up is
easily done through Computer Setup. See
CAUTION:
password or the power-on password, the computer is inaccessible and can no longer be used.
Enabling the stringent password disables the ability to reset the password by moving the jumper on the
system board.
If you lose or forget the password, the system board must be replaced. This scenario is not covered
under warranty.
To prevent the computer from becoming permanently unusable, record your configured setup password
or power-on password in a safe place away from your computer. Without these passwords, the
computer cannot be unlocked.
160 Chapter 11 Password Security and Resetting CMOS
Pushing the CMOS button will reset CMOS values to factory defaults. It is important to
If you enable the stringent security feature in Computer Setup and you forget the setup
Computer Setup (F10) Utility on page 83 for information.