Installation - Polaris RANGER RZR 170 Service Manual

BRAKES
NOTE: Dispose of fluid properly. Do not re-use.
A
14.5 ft-lb. (19.6 Nm)
B
5. Remove clip (C) and disconnect brake actuator rod
clevis from brake pedal.
6. Remove the two mounting fasteners (D) that secure
the master cylinder to the frame.
C
D
6.26
15 in-lb. (1.7 Nm)
17.5 ft-lb. (23.0 Nm)
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.

Installation

1. Reverse Steps 1-5 for master cylinder installation.
Refer to the torque specifications in the removal
steps. Install new sealing washers on brake lines.
2. After installing the master cylinder, perform the
following:
• Fill the reservoir with Polaris Dot 4 Brake Fluid (PN
2872189) from a new, sealed container.
• Bleed the master cylinder and both front and rear
brake lines and calipers. See "BRAKE BLEEDING
/ FLUID CHANGE" on page 6.7.
• Inspect pedal free play and pedal travel. See
"Brake Pedal Inspection / Adjustment" on
page 6.9.
• Test brake system for proper function before
returning the vehicle to service.