Rear Brake Caliper Installation - Polaris RANGER RZR 170 Service Manual

BRAKES
NOTE: The parking
disconnected by loosening jam nut (C) and backing
out adjuster bolt (D) a few turns.
7. Remove two caliper mounting bolts and caliper
assembly.
8. Place a container below caliper to catch brake fluid
and remove brake line from caliper. Immediately
cover and seal end of brake line to prevent
contamination.
6.24
brake cable can
C
D
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
be

Rear Brake Caliper Installation

1. Install caliper and torque mounting bolts to
specification.
Rear Caliper Mount Bolt:
Brake Line Banjo Bolt:
2. Bleed rear brake system. See "BRAKE BLEEDING /
FLUID CHANGE" on page 6.7.
3. Attach parking brake cable to lever arm with one
washer (A) on each ends of spring. If lever arm plate
was removed, install plate and torque bolts (B) to 12
ft-lbs. (16 Nm).
B
18 ft-lb. (24.5 Nm)
14.5 ft-lb. (19.6 Nm)
= T
18 ft-lbs (24.5 Nm)
= T
14.5 ft-lbs (19.6 Nm)
A