Parking Brake Cable Replacement - Polaris RANGER RZR 170 Service Manual

Parking Brake Cable Replacement

1. Release parking brake. Turn the cable adjuster
located near the rear caliper inwards until fully
seated.
2. Pull cable casing forward and slide cable out of holder,
then remove cable from lever arm.
3. Cut tie strap and release cable from guide.
WARNING
Use care when supporting vehicle so that it
does not tip or fall. Severe injury or death may occur
if the vehicle tips or falls.
NOTE: If you do not have the proper equipment to
safely lift and securely support the vehicle, refer to
Chapter 5 for information on removing the seats,
rear access panel, and battery tray panel to reach
the parking brake cable and brake lever from the top.
4. Have an assistant help tip the vehicle toward the
passenger side, or secure vehicle to a lift that allows
access to the underside.
5. Secure the vehicle in position and place jack stands
under the front and rear areas of the frame.
6. Note location of tie straps for assembly. Cut all tie
straps.
7. Cable routes on passenger side of shift cables as
shown.
8. Hold cable adjuster nut (10mm wrench). Loosen the
jam nut (12mm wrench), and turn adjuster nut fully
inward to gain maximum cable slack.
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
BRAKES
6
6.11