Swing Arm Installation - Polaris RANGER RZR 170 Service Manual

8. Remove the (2) swing arm through-bolts.
NOTE: Lower the vehicle slightly to ease removal.
9. Remove the drive chain from the front drive sprocket
10. Roll the swing arm assembly out from the vehicle.
11. Refer to the "Axle Housing Removal" procedure, if
replacing the swing arm.

Swing Arm Installation

1. Roll the swing arm assembly back into place and
install the drive chain over the front sprocket.
2. Line up the swing arm with the frame and install the
through-bolts. Torque the swing arm bolts to
specification.
Swing Arm Mounting Bolts:
72 ft-lbs (98 Nm)
= T
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
BODY / SUSPENSION / STEERING
3. Install a new tie strap to retain the brake lines.
Tie Strap
4. Line up the upper shock eyelets with the frame
mounting holes and install the mounting bolts. Torque
the rear shock mounting bolts to specification.
Rear Shock Mounting Bolts:
43 ft-lbs (58 Nm)
5. Install the rear brake caliper and torque the mounting
bolts to specification.
Brake Caliper Bolts:
18 ft-lbs (24 Nm)
6. Remove the wire or strap retaining the chain tensioner
, allowing it to return to its normal position.
7. Lower the rear end of the vehicle and perform the
chain adjustment procedure
"Maintenance").
8. Be sure the rear axle housing fasteners are torqued
to specification.
Rear Axle Housing Bolts:
72 ft-lbs (98 Nm)
= T
= T
(see Chapter 2
= T
5.21
5