Polaris RANGER RZR 170 Service Manual page 162

BRAKES
8. Tighten bleed screw securely and remove hose.
Torque bleed screw to 47 in-lbs (5.3 Nm). Install
protective cap.
9. Repeat Steps 4 - 8 for remaining master cylinder bleed
screw, then proceed to caliper bleeding procedure.
Caliper Bleeding
10. The bleeding process is the same for the calipers as
for the master cylinder. Use the bleed screw on each
caliper. Perform Steps 4-8 for each front caliper.
Maintain at least 1/2"(1.27 cm) of brake fluid in
the reservoir at all times to prevent air from
entering the master cylinder.
11. Perform Steps 4-8 for the rear caliper.
6.8
CAUTION
Open
Close
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
12. Add brake fluid to MAX level inside reservoir.
Master Cylinder Fluid Level
Between the MIN and MAX line
shown on the reservoir.
13. Install master cylinder reservoir cover securely.
14. Field test the vehicle at low speed before putting into
service. Check for proper braking action and inspect
pedal travel.
15. Perform brake pedal inspection. See "Brake Pedal
Inspection / Adjustment" on page 6.9.
16. Check brake system for fluid leaks.