BODY / SUSPENSION / STEERING
Hub Seal and Bearing Replacement
1. Remove the (6) bolts retaining the brake disc to the
hub.
2. Remove the outer spacer from the hub.
3. Remove the seals from each end of the hub and press
the bearings and spacer tube out.
4. Using an arbor press, install new bearings along with
the spacer tube back into the hub.
5.16
5. Install new seals on each end of the hub. Press the
6. Reinstall the brake disc with new mounting bolts.
7. Reinstall outer spacer into the outer hub seal.
Hub Installation
1. Grease the spindle and reinstall the front hub
2. Install the brake caliper and torque the mounting bolts
9923983 - 2012-2013 RZR 170 Service Manual
© Copyright 2012 Polaris Sales Inc.
seals into the hub until the top of the seal is just past
the chamfer.
Chamfer
Torque the bolts to specification.
Front Brake Disc Bolts:
7 ft-lbs (10 Nm)
assembly.
Grease
to specification.
Brake Caliper Bolts:
18 ft-lbs (24 Nm)
= T
= T