Galileo Concerto User Manual page 37

Concerto
CONTROL CHANGE ON/OFF – F6.5
This function allows you to enable or disable the transmission and reception of Control
Change messages.
When you modify the panel controls, such as the pedals or the [BALANCE] slider, the
instrument automatically transmits the relative Control Change to set the receiver instrument
in the same way. In reception mode, the instrument also modifies its parameters when it
receives CC messages.
To set up this function, select "F6.5" on the display and press [DEMO/ENTER].
Use the [VALUE] buttons to make the setting. The default condition ([VALUE] buttons
pressed simultaneously) is On.
NOTA
For information about the association between Control Changes and
controls on the panel, consult the "MIDI Implementation Chart" at the back
of the manual.
MIDI TRANSMIT TRANSPOSE – F6.6
This function allows you to transpose the MIDI note data in relation to the notes played on
the piano keyboard, within a range of +/- 12 semitones (+/- one octave). Using this setting
you can therefore play the piano and the instrument connected by MIDI in two different
keys, obtaining a complete range of pitch intervals.
After selecting "F6.6" on the display, press [DEMO/ENTER]. The system will display the
current MIDI transposition value; use the [VALUE] buttons to vary it, bearing in mind that
settings are made in steps of one semitone.
To restore the default value (0), press the [VALUE] buttons simultaneously.
NOTE
If a MIDI Transmit Transpose value different from 0 is set, this does not
change the pitch of the piano itself.
35
User Manual