Settings; Changing The Parameters; Accessing The Installer Level; List Of Parameters - REMEHA Quinta Ace 30 Installation And User Manual

8

Settings

8.1

Changing the parameters

Tab.34 CU-GH08
Icon Zone or function
CIRCA / CH
Gas fired appliance
Tab.35 Configuring a zone or function of CU-GH08 or
Parameters, counters, signals
Parameters
Counters
Signals
Adv. Parameters
Adv. Counters
Adv. Signals
8.2

List of parameters

7684359 - v.06 - 10012019
The boiler's control unit is set for the most common central heating
systems. These settings will ensure that virtually every central heating
system operates effectively. The user or the installer can optimise the
parameters as required.
Caution
Changing the factory settings may adversely affect the operation
of the boiler.
For more information, see
Additional documentation, page 10
8.1.1

Accessing the installer level

Some parameters that may affect the operation of the boiler are protected
by an access code. Only the installer is allowed to modify these
parameters.
1. Select the tile [
2. Enter code: 0012
When the installer level is active, the status of the tile [
from Off into On.
3. To leave the installer level, select the tile [
When the control panel is not used for 30 minutes, the installer level is left
automatically.
Configuring the installation at installer level
Configure the installation by pressing the [
Installation Setup
configure:
Description
Central heating circuit
Gas boiler
Description
Set the parameters at installer level
Read the counters at installer level
Read the signals at installer level
Set the parameters at advanced installer level
Read the counters at advanced installer level
Read the signals at advanced installer level
The code of the parameters always contain two letters and three numbers.
The letters stand for:
AP Appliance related parameters
CP Zone related parameters
DP Domestic hot water related parameters
].
]-button and selecting
. Select the control unit or circuit board you want to
8 Settings
] changes
] > Confirm.
41