Electronic Board Operations Check - Panasonic UB-5315 Operating Instructions Manual

Electronic Board Operations Check

After assembling the electronic board, perform the procedures presented in the following table to make sure it
functions properly.
Step
1 Turn on the power switch.
2
Open the printer door and attach
the accessory thermal transfer film,
then close the printer door.
• Installing Thermal Transfer Film
procedure (refer to the Operating
Instructions page 10, 11)
3 Open the paper cover and insert
ordinary Letter test paper, then
close the paper cover.
• Loading Copy Paper procedure
(refer to the Operating
Instructions page 12, 13)
4 Open the printer door.
5 Close the printer door.
6
Press .
7
Use the accessory marker to
draw a large
entire copyable area of the
screen film surface.
• Copyable area (refer to the
Operating Instructions
page 7)
Press
Press
8
Press
film surface. Write letters, etc.
with the marker.
Press
Press
9
Press once.
10
Press .
44
filling the
twice.
.
to move the screen
once.
.
Symptom
" " flashes after " " lights up.
(If not)
" " flashes.
(If not)
" " lights up.
(If not)
" " flashes.
(If not)
" " lights up.
(If not)
Screen is fed.
The screen film surface is not
fed smoothly.
There are strange noises.
" " lights up and three copies
are made.
Three copies are not made.
The entire readable area is not
printed.
There are strange noises or
paper jams during the copying
process.
Multiple sheets of paper are
fed through at the same time.
The Contrast/Remaining Film
indicator light is not turned on.
The image is not copied
properly.
There are strange markings on
the copy sheet
(e.g., stripes or lines).
The Contrast/Remaining Film
indicator light is not turned off.
Two screens are not copied
properly.
Points to Check
Solutions
(Normal operation)
Check power cord and cables.
(See step 23 on page 43 and
step 18 on page 42.)
(Normal operation)
Check thermal transfer film.
(Normal operation)
Check copy paper.
(Normal operation)
Check printer cables.
(Normal operation)
Check printer cables.
(Normal operation)
Contact the store or dealer
from which the unit was
purchased.
(Normal operation)
Contact the store or dealer
from which the unit was
purchased.
Contact the store or dealer
from which the unit was
purchased.
Contact the store or dealer from
which the unit was purchased.
Contact the store or dealer from
which the unit was purchased.