Wall-Mounting Procedure - Panasonic UB-5315 Operating Instructions Manual

■ Wall-mounting procedure

1
Confirm that the wall is strong enough to support the weight of the electronic board.
Caution
The wall must be capable of supporting at least
1226N [125 kgf (276 lbs.)] for UB-5315
1324N [135 kgf (298 lbs.)] for UB-5815.
2
1) Assemble the wall-mounting template by taping the Wall-mounting template 1
(TOP) to Wall-mounting template 2 (BOTTOM).
2) Tape the wall-mounting template on the wall.
• When taping the template on the wall, make sure it is level.
3
1) Drill holes in the wall at the 4 spots indicated by
wall-mounting fixtures.
• Holes on the wall-mounting fixture are
2) After removing the wall-mounting template, attach the wall-mounting fixtures
with the appropriate wall-mounting hardware.
Board attachment (upper)
(Wall-mounting fixture upper)
Board attachment (lower)
(Wall-mounting fixture lower)
Remove the
edge cover.
• Refer to the section "Attaching the wall-mounting fixtures" (page 52) for drilling in the wall and attaching the
mounting fixtures.
• Refer to steps 2 to 23 on pages 37 to 43 for attaching the printer and the screen.
1
/ " in diameter.
4
Center of the electronic board
A
A
B
A
B
A
B
Wall-mounting hardware
and
A
B
Wall-mounting hardware
C
Wall-mounting
, or and for the
C B C
Wall-mounting
C
template
C
940 mm
(3' 1" )
C
Remove the
edge cover.
51