Panasonic UB-5315 Operating Instructions Manual page 43

22
Attach the cover (lower).
Push the cover in the direction of
the arrow until it clicks.
Fix the cover with the wing bolt.
(UB-5815
only)
23
Attach the power cord.
Securely fit the supplied power cord
into the AC inlet on the printer unit.
Caution
• The power cord should be held in the cord
holder.
AC inlet
Power cord
Cord holder
Assembling the Electronic Board
24
Attach the rear cover. (only for use
of the optional stand)
Rivets
• After peeling off the cover sheets of the
adhesive tapes, attach the rear cover to the
board attachments (upper/lower) while
matching the top edges of them. Then install
the rivets
• The rear cover and rivets are supplied with
the optional stand.
25
Wipe the screen film surface.
Soak a soft cloth with water, wring
well, and wipe the screen film surface.
Caution
• Do not wipe the screen film surface with paint
thinner, benzene, or cleaners that contain
abrasives. Doing so may cause discoloration.
• Do not wipe the screen film surface with a dry
cloth. Doing so may create static electricity.
26
Check the operations.
Refer to "Electronic Board Operations
Check" on page 44.
Adhesive
tape
43