HP 5920 Series Configuration Manual page 37

Specifying a VPN for the scheme
The VPN specified for a RADIUS scheme applies to all authentication and accounting servers in that
scheme. If a VPN is also configured for an individual RADIUS server, the VPN specified for the RADIUS
scheme does not take effect on that server.
To specify a VPN for a scheme:
Step
1. Enter system view.
2. Enter RADIUS scheme view.
3. Specify a VPN for the RADIUS
scheme.
Setting the username format and traffic statistics units
A username is typically in the format userid@isp-name, where isp-name represents the user's ISP domain
name. By default, the ISP domain name is included in a username. However, older RADIUS servers might
not recognize usernames that contain the ISP domain names. In this case, you can configure the device
to remove the domain name of each username to be sent.
For correct identification of users, do not configure the device to remove the ISP domain names from
usernames for the RADIUS scheme that is referenced by two or more ISP domains.
The device reports online user traffic statistics in accounting packets. The traffic measurement units are
configurable, but they must be the same as configured on the RADIUS accounting servers.
To set the username format and the traffic statistics units for a RADIUS scheme:
Step
1. Enter system view.
2. Enter RADIUS scheme view.
3. Set the format for usernames
sent to the RADIUS servers.
Command
system-view
radius scheme radius-scheme-name
vpn-instance vpn-instance-name
Command
system-view
radius scheme
radius-scheme-name
user-name-format { keep-original
| with-domain | without-domain }
26
Remarks
N/A
N/A
By default, a RADIUS scheme
belongs to the public network.
Remarks
N/A
N/A
The default setting depends on the
type of startup configuration used:
•
If the device starts up with initial
settings, the ISP domain name
is included in a username.
•
If the device starts up with the
default configuration file, it
removes the ISP domain name
from usernames to be sent to
the RADIUS servers that are
specified in the predefined
RADIUS scheme system.
For more information about the
startup configuration, see
Fundamentals Configuration
Guide.