Configuring An Authentication Destination Subnet - HP 5920 Series Configuration Manual

Step
1. Enter system view.
2. Enter interface view.
Configure an IPv4 portal
3.
authentication source subnet.
To configure an IPv6 portal authentication source subnet:
Step
1. Enter system view.
2. Enter interface view.
3. Configure an IPv6 portal
authentication source subnet.

Configuring an authentication destination subnet

By configuring authentication destination subnets, you specify that users trigger portal authentication
only when they accessing the specified subnets (excluding the destination IP addresses and subnets
specified in portal-free rules). Users can access other subnets without portal authentication.
If both authentication source subnets and destination subnets are configured on an interface, only the
authentication destination subnets take effect.
You can configure multiple authentication destination subnets. If the destination subnets overlap, the
subnet with the largest address scope (with the smallest mask or prefix) takes effect.
To configure an IPv4 portal authentication destination subnet:
Step
1. Enter system view.
2. Enter interface view.
3. Configure an IPv4
portal authentication
destination subnet.
To configure an IPv6 portal authentication destination subnet:
Command
system-view
interface interface-type
interface-number
portal layer3 source
ipv4-network-address
{ mask-length | mask }
Command
system-view
interface interface-type
interface-number
portal ipv6 layer3 source
ipv6-network-address prefix-length
Command
system-view
interface interface-type interface-number
portal free-all except destination
ipv4-network-address { mask-length |
mask }
99
Remarks
N/A
N/A
By default, no IPv4 portal
authentication source subnet is
configured, and users from any
subnets must pass portal
authentication.
Remarks
N/A
N/A
By default, no IPv6 portal
authentication source subnet is
configured, and IPv6 users from
any subnets must pass portal
authentication.
Remarks
N/A
N/A
By default, no IPv4 portal
authentication destination subnet is
configured, and users accessing any
subnets must pass portal
authentication.