Network application
Figure 122 Network diagram
Configure strict uRPF check between an ISP network and a customer network, and loose uRPF check
between ISPs.
Configuring uRPF
When you configure uRPF, follow these restrictions and guidelines:
Global uRPF configuration takes effect on both IPv4 and IPv6 routes.
•
•
uRPF checks only incoming packets on an interface.
After you enable the uRPF function on the switch, the routing table size might decrease by half.
•
•
If the number of routes exceeds half the routing table size of the switch, the uRPF function cannot be
enabled to avoid loss of routes and packets.
To enable uRPF globally:
Step
1.
Enter system view.
2.
Enable uRPF globally.
ISP A
ISP B
User
Command
system-view
ip urpf { loose | strict }
356
uRPF (loose)
ISP C
uRPF (strict)
Remarks
N/A
By default, uRPF is disabled.