Configuring Snmp Notifications For Ike; Displaying And Maintaining Ike - HP 5920 Series Configuration Manual

Configuring SNMP notifications for IKE

After you enable SNMP notifications for IKE, the IKE module notifies the NMS of important module events.
The notifications are sent to the device's SNMP module. You can configure the notification transmission
parameters for the SNMP module to specify how the SNMP module displays notifications. For more
information about SNMP notifications, see Network Management and Monitoring Configuration
Guide.
To generate and output SNMP notifications for IKE for a specific failure or event type, enable SNMP
notifications for IKE globally and for the specified type of failures or events.
To configure SNMP notifications for IKE:
Step
1. Enter system view
2. Enable SNMP
notifications for IKE
globally.
3. Enable SNMP
notifications for the
specified failure or
event type.

Displaying and maintaining IKE

Execute display commands in any view and reset commands in user view.
Task
Display configuration information about all IKE
proposals.
Display information about the current IKE SAs.
Delete IKE SAs.
Clear IKE MIB statistics.
Command
system-view
snmp-agent trap enable ike global
snmp-agent trap enable ike [ attr-not-support
| auth-failure | cert-type-unsupport |
cert-unavailable | decrypt-failure |
encrypt-failure | invalid-cert-auth |
invalid-cookie | invalid-id | invalid-proposal
| invalid-protocol | invalid-sign |
no-sa-failure | proposal-add |
proposal–delete | tunnel-start | tunnel-stop
| unsupport-exch-type ] *
261
Remarks
N/A
By default, SNMP notifications
for IKE are enabled.
By default, SNMP notifications
for all failure and event types
are enabled.
Command
display ike proposal
display ike sa [ verbose [ connection-id connection-id
| remote-address [ ipv6 ] remote-address
[ vpn-instance vpn-name ] ] ]
reset ike sa [ connection-id connection-id ]
reset ike statistics