Setting The Maximum Number Of Portal Users; Specifying A Portal Authentication Domain - HP 5920 Series Configuration Manual

Step
1. Enter system view.
2. Enter interface view.
3. Configure an IPv6
portal authentication
destination subnet.

Setting the maximum number of portal users

Perform this task to control the total number of portal users allowed in the system.
If you configure the maximum total number smaller than the number of current online portal users on the
device, this configuration still takes effect. The online users are not affected but the system forbids new
portal users to log in.
Step
1. Enter system view.
2. Set the maximum number of
total portal users.

Specifying a portal authentication domain

An authentication domain defines a set of authentication, authorization, and accounting policies. Each
portal user belongs to an authentication domain and is authenticated, authorized, and accounted in the
domain.
After you specify a portal authentication domain on an interface, the device uses the specified
authentication domain for AAA of all portal users on the interface, ignoring the domain names carried
in the usernames. This allows for flexible portal access control.
The device selects the authentication domain for a portal user on an interface in this order:
1. ISP domain specified for the interface.
2. ISP domain carried in the username.
3. System default ISP domain. For information about the default ISP domain, see
You can specify an IPv4 portal authentication domain, an IPv6 portal authentication domain, or both on
an interface.
To specify an IPv4 portal authentication domain:
Step
1. Enter system view.
2. Enter interface view.
Command
system-view
interface interface-type interface-number
portal ipv6 free-all except destination
ipv6-network-address prefix-length
Command
system-view
portal max-user max-number
Command
system-view
interface interface-type
interface-number
100
Remarks
N/A
N/A
By default, no IPv6 portal
authentication destination subnet is
configured, and users accessing any
subnets must pass portal
authentication.
Remarks
N/A
By default, no limit is set on the
number of portal users in the system.
"Configuring
Remarks
N/A
N/A
AAA."