To specify the IP addresses of servers:
Step
1.
Enter system view.
2.
Enter VLAN view.
3.
Specify the IP addresses of
servers.
Displaying and maintaining MFF
Execute display commands in any view.
Task
Display MFF port configuration information.
Display the MFF configuration information for a VLAN.
MFF configuration examples
Manual-mode MFF configuration example in a tree network
Network requirements
As shown in
manually.
Configure MFF to isolate the hosts at Layer 2 and allow them to communicate with each other through the
gateway at Layer 3.
Command
system-view
vlan vlan-id
mac-forced-forwarding server
server-ip&<1-10>
Figure 1
18, all the devices are in VLAN 100. Hosts A, B, and C are assigned IP addresses
Command
display mac-forced-forwarding interface
display mac-forced-forwarding vlan vlan-id
349
Remarks
N/A
N/A
By default, no server IP address is
specified.
If the server's interface connecting
to the MFF device uses secondary IP
addresses to send ARP packets,
include all these IP addresses in the
server IP address list.