Logging; Fips Compliance; Password Control Configuration Task List; Enabling Password Control - HP 5920 Series Configuration Manual

Logging

The system logs all successful password changing events and user adding events to the password control
blacklist.

FIPS compliance

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode (see

Password control configuration task list

The password control features can be configured in several different views, and different views support
different features. The settings configured in different views or for different objects have the following
application ranges:
Settings for super passwords apply only to super passwords.
•
Settings in local user view apply only to the password of the local user.
•
Settings in user group view apply to the passwords of the local users in the user group if you do not
•
configure password policies for these users in local user view.
• Global settings in system view apply to the passwords of the local users in all user groups if you do
not configure password policies for these users in both local user view and user group view.
For local user passwords, the settings with a smaller application scope have higher priority.
To configure password control, perform the following tasks:
Tasks at a glance
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Enabling password control

To successfully enable the global password control feature and allow device management users to log in
to the device, the device must have sufficient storage space.
Enabling the global password control feature is the prerequisite for all password control configurations
to take effect. Then, for a specific password control feature to take effect, enable this password control
feature.
After the global password control feature is enabled, you cannot display the password and super
password configurations for device management users by using the corresponding display commands.
However, the configuration for network access user passwords can be displayed. The first password
configured for device management users must contain at least four different characters.
Enabling password control
Setting global password control parameters
Setting user group password control parameters
Setting local user password control parameters
Setting super password control parameters
"Configuring
167
FIPS") and non-FIPS mode.