Preparing The Windows 2003 Server And Juniper Radius; Installing Windows 2003 Server; Procedure 2-3 Windows 2003 Server Installation - Motorola 2.1 Networking Setup Manual

Chapter 2: Network Setup
If the bind and DHCP services were started, it is important to verify that a second machine
20
is able to receive an IP address. Configure a second machine to receive an IP address via
DHCP from the MiSC.
Installing the One Point Wireless Manager™ Application
Now that the Linux operating system and DHCP/DNS scripts have been installed on our
server, we can now install the One Point Wireless Manager™ Application.
For information about how to install this application, please refer to the WMS Setup and
Installation Guide found on the provided product CDs. If you require information about
upgrading an existing MOTOMESH Duo system, please refer to the MOTOMESH Duo 2.1
Field Upgrade Procedures documentation, also found on the provided product CDs.

Preparing the Windows 2003 Server and Juniper RADIUS

Installing Windows 2003 Server

As discussed in the section detailing the small system reference design a Windows 2003
server will be configured with RADIUS to support EAP-TTLS Secure Mesh. In this example
we will be installing Windows 2003 Server on an HP DL360 G5 server.
The following installation procedure requires valid Windows 2003 R2 Second Edition media
and license and the HP Smart Start CD from the HP ProLiant Essentials Foundation Pack.
Procedure 2-3 Windows 2003 Server Installation
Insert the Windows 2003 Server Standard Edition CD in the CD drive.
1
Reboot the PC and the system should boot from the CD. If the systems does not boot from the
CD, use system setup to alter the BIOS device boot order to boot from CD before the hard
drive.
From the Windows setup screen, press Enter to start the installation.
2
If an existing installation is detected, the installer will offer the opportunity to repair it. Follow the
on-screen instructions to continue with a new installation..
At the next screen, press F8 to agree to the software license.
3
The next screen lists the current disk setup.
4
Use D to delete any existing partitions, follow the on-screen instructions to confirm the
deletions.
The screen should show the entire disk as unpartitioned space. Press C to create a partition.
5
The default is to use the entire disk. Press Enter to accept this.
At the disk setup screen, select the new partition and press Enter to start the installation
6
process. Use Enter again to format the disk with an NTFS files system.
2-22