Personality Plug; Standard / Canopy Connect Poe Plug Usage Information; Figure 3-4 Select Port; Procedure 3-1 Personality Plug Usage Information - Motorola 2.1 Networking Setup Manual

Chapter 3: MOTOMESH Duo Hardware

Personality Plug

There are three available color coded personality plugs that can be attached to the select port.
•
Canopy Connect Part # 363344B01 (Black) – If a black plug is attached to the
Select port Motorola Canopy based PoE to power Canopy Subscriber Modules will
be sourced on the POE OPT port.
•
Standard PoE Part # 286335B01 (White) - If a white plug is attached to the Select
port 802.3af standards based PoE will be sourced on the POE OPT port.
•
Reset Part # 3863343B01 (Red) – If a red plug is attached to the Select port the
MOTOMESH Duo device will be reset to factory defaults.
Figure 3-4

Standard / Canopy Connect PoE Plug Usage Information

Procedure 3-1

Personality Plug Usage Information
With the MOTOMESH Duo device powered off, connect an external PoE device to the POE OPT
1
port with the Ethernet cable provided.
Connect the Canopy Connect or Standards based 802.3af PoE Personality Plug to the Select
2
Port (shown above) AFTER the Ethernet cable has been connected to the desired external
device.
Apply power to the MOTOMESH Duo device.
3
Select Port
3-5