Cisco 3750 L3 Switch Core Configuration File - Motorola 2.1 Networking Setup Manual

Appendix A:
configure terminal
5
interface vlan 1
6
[interface-id]
ip directed-broadcast
7
exit
8
ip forward-protocol
9
snmp
end
10
show ip interface
11
[interface-id]
or
show running-config
copy running-config
12
startup-config
Documentation Credits: Some source information for this procedure was extracted from the Cisco
Catalyst 3750 Software Configuration Guide.

Cisco 3750 L3 Switch Core Configuration File

The contents of the Cisco 3750 standard production file are shown.
Using 4445 out of 524288 bytes
!
version 12.2
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname L3-CORE
!
enable secret 5 $1$Ug./$VMDwCPRbtHyUcMsOq.6u90
Enter global configuration mode.
Enter interface configuration mode, and specify the interface to
configure.
(In this case vlan 1)
Enable directed broadcast-to-physical broadcast translation on the
interface.
Note: The ip directed-broadcast interface configuration command
can be configured on a VPN routing/forwarding (VRF) interface and is
VRF-aware. Directed broadcast traffic is routed only within the VRF.
Return to global configuration mode.
Specify which protocols and ports the router forwards when forwarding
udp
broadcast packets.
Return to privileged EXEC mode.
Verify the configuration on the interface or all interfaces
vlan 1).
(Optional) Save your entries in the configuration file.
9-2
(in this case