Part Ii - Power Cable With Flying Leads; Part Iii - Power Connector And Cable Assembly Instructions - Motorola 2.1 Networking Setup Manual

Appendix A:
Part II – Power Cable with Flying Leads
1.
The initial Power Cable will have three wires: Brown (Line), Blue (Neutral), and Green/Yellow
(Ground/Earth).
Figure 9-28
Part III – Power Connector and Cable Assembly Instructions
2.
Loosen the Strain Relief Screws on the plug.
Figure 9-29
Strain Relief Screws
3.
Place the three wires under the Strain Relief Bar and pull through. Allow the Blue and Green
Wire to pull through on the left side of the Screw Well and the Brown Wire to pull through on the
right hand side of the Screw Well.
Power Cable with Wire Designation
Inside View Pointing out Strain Relief Bar and Screws
Strain Relief Bar
9-23
Brown Wire is Line
Blue Wire is Neutral
GREEN/Yellow Wire is Earth