Table of Contents
Advertisement
Chapter 2: Network Setup
Authentication Server Configuration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Juniper Steel-Belted RADIUS
This section describes how to configure Juniper Steel Belted Radius server in support of
EAP-TTLS Secure Mesh. Any Radius server package can be used as long as it supports
EAP-TTLS authentication.
The pre-requisites for the procedure in this section are:
•
•
•
•
After the installation SBR is complete we need to add our trusted root and server certificate to our Steel
Belted Radius server.
Exporting Certificates
Procedure 2-9 describes how to export existing certificates and install them for use with
Steel-Belted RADIUS.
Procedure 2-9
Exporting Certificates
With the installation of our certificate authority in the previous section and the creation of a server
certificate we need to add these to Steel Belted Radius.
Find the server certificate installed on the authentication server.
1
• Click Start | Run | and type MMC.exe. Press enter.
• Browse to the certificate store by selecting: Console / Add/Remove Snap-in / Add... /
Certificates / Computer Account.
Result: The select PC dialog appears.
• Select Local Computer.
• Open the Personal / Certificates folder in its tree view.
• A server certificate was created when we created our Certificate Authority. In our
reference design this certificate will be named radius.
Windows 2003 server installation complete.
Installation of our Certificate Authority (CA).
Creation of a server certificate.
Steel Belted Radius Enterprise Edition (available from Juniper.net). Download /
purchase SBR installer and proceed to install the program by double clicking the
installer. We download an evaluation copy of this example. Contact Juniper
Networks to purchase a licensed copy.
.
.
2-28
Advertisement
Chapters
Table of Contents
