1. Manuals
  2. Brands
  3. Motorola Manuals
  4. Network Hardware
  5. 2.1
  6. Networking setup manual

Figure 4-18 Tighten The Bracket Screws; Figure 4-19 Remove The Protective Cap - Motorola 2.1 Networking Setup Manual

Motorola network hardware user manual
Hide thumbs
Table of Contents

Advertisement

Chapter 4: Site Selection and Deployment Guidelines
Figure 4-18
Tighten the bracket screws
If your MOTOMESH Duo device is going to be used as an IAP remove the protective cap on the POE
OPT Ethernet port. The POE OPT port is configured by default to be used as the backhaul port. Note
that this port is NOT powered unless a personality plug is attached to the select port. Please see Chapter
3 for more information. Note that the Ethernet cable and port are keyed.
Figure 4-19
Remove the protective cap
4-11

Advertisement

Table of Contents
loading

Related Manuals for Motorola 2.1

Related Content for Motorola 2.1

This manual is also suitable for:

Motomesh duo 2.1

Table of Contents