Removing Left-Side Components; Recoil Starter (Utility) - Arctic Cat ATV 300 Utility/DVX 300 2011 Service Manual

For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
11. Install the cam chain tensioner cover bolt and tighten
to 24 in.-lb.
12. Check that the cam gear alignment marks are cor-
rectly oriented; then install and tighten the external
cylinder head to cylinder cap screws to 7 ft-lb.
13. Install the cylinder head cover with a new O-ring and
tighten securely.
Left-Side Components
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
34
Removing Left-Side
A. Recoil Starter (Utility)
1. Remove the five recoil starter cover cap screws.
Remove the recoil starter assembly noting the loca-
tion of the dowel pins. Note the condition of the
recoil cover gasket. Replace if damaged.
KM705
To service the recoil starter, see Servicing Left-Side
Components sub-section.
B. V-Belt Cover
C. Drive Pulley
D. Driven Pulley/Centrifugal Clutch
Assembly
 NOTE: On the Utility, step 1 in the preceding sub-
section must precede this procedure.
2. Remove the ten cap screws securing the V-belt
cover; then remove the cover noting the location of
the two dowel pins. Note the condition of the V-belt
cover gasket. Replace if damaged.
KM703
3. On the Utility using a suitable holder to prevent the
drive pulley from turning, remove the drive face nut
and starter ratchet; then remove the drive pulley face.
4. Hold the centrifugal clutch with a suitable holder;
then remove the clutch retaining nut and clutch collar.
www.mymowerparts.com
Manual
Table of Contents
Components
AT THIS POINT

KM253
KM365