V-Belt Cover - Arctic Cat ATV 300 Utility/DVX 300 2011 Service Manual

For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
6. Install the ratchets making sure the ends are properly
oriented on the reel.
7. Install the spacer, spring, and the ratchet guide mak-
ing sure the ratchet pins engage the guide.
8. Hold the ratchet guide down in place on the ratchet
pins and secure with the cap screw coated with blue
Loctite #243. Tighten securely.
KM402A
9. With the 50 cm (20 in.) of rope exposed, hook the
rope in the notch of the reel.
10. Rotate the reel four turns clockwise; then release the
rope from the notch and allow the rope to retract.
11. Pull the rope out two or three times to check for cor-
rect tension and ratchet extender.
KM397A
 NOTE: Increasing the rotations in step 10 will
increase spring tension.
12. Place the recoil starter assembly into position on the
left-side cover; then tighten the cap screws to securely.

V-BELT COVER

1. Inspect the bearing for excessive wear, rough or
binding when turning, seal condition, and secure
mounting in the V-belt cover.
 NOTE: If the bearing is worn excessively, turns
KM401
roughly, or bearing seals are loose, the bearings
must be replaced.
www.mymowerparts.com
Manual
Table of Contents
KM410
KM412
KM254
37