Front And Rear Suspension Assembly Schematics; Front Shock Absorbers - Arctic Cat ATV 300 Utility/DVX 300 2011 Service Manual

For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
Suspension
The following suspension system components should be
inspected periodically to ensure proper operation.
A. Shock absorber rods not bent, pitted, or damaged.
B. Rubber damper not cracked, broken, or missing.
C. Shock absorber body not damaged, punctured, or
leaking.
D. Shock absorber eyelets not broken, bent, or
cracked.
E. Shock absorber eyelet bushings not worn, deterio-
rated, cracked, or missing.
F. Shock absorber spring not broken or sagging.
Front and Rear
Suspension Assembly
Schematics
REMOVING
1. Secure the ATV on a support stand to elevate the
Make sure the ATV is solidly supported on the support
stand to avoid injury.
2. Remove the cap screws and nuts securing each shock
KM598E
Utility
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively, cracked,
or damaged in any way, replacement is necessary.
1. Clean the shock absorbers in parts-cleaning solvent.
2. Inspect each shock rod for nicks, pits, bends, and
3. Inspect the springs, spring retainers, shock rods,
KM463
INSTALLING
1. Install each shock absorber to the frame and A-arm
Do not tighten the nut beyond the recommended speci-
www.mymowerparts.com
fication or the shock eyelet or mount WILL be damaged.
Manual
Table of Contents

Front Shock Absorbers

wheels and to release load on the suspension.
! WARNING
absorber to the A-arm and frame.
oily residue.
shock bodies, and eyelets for cracks, leaks, and
bends.
with cap screws and nuts. Tighten all nuts to 29 ft-lb.
CAUTION
DVX
KM462
KM573A
97