Battery Replacement - Golden Technologies Buzzaround XL GB146 Service Manual

Table of Contents

Advertisement

8. Install the throttle lever onto the new throttle pot.
9. Install the new throttle pot onto the tiller shroud.
10. Connect the new throttle pot to the control panel harness.
11. Reinstall the back tiller shroud onto the tiller.
12. Reinstall the control panel onto the tiller.
13. Reinstall the control panel cover.

BATTERY REPLACEMENT

Tools needed: Phillips screwdriver and adjustable wrench
1. Place the freewheel lever in the engaged
position.
2. Remove the key from the key switch.
3. Rotate the seat so that it is facing the side.
4. Remove the battery pack.
5. Position the battery pack so that the screw heads
are facing up. See gure 32.
6. Use an adjustable wrench to loosen the circuit
breaker button cover. See gure 32.
7. Remove the eleven (11) screws that fasten the
battery pack together. See gure 32.
8. Turn the battery pack over so that the screw
holes are facing down. See gure 33.
9. Remove the top of the of the battery pack.
Note the position of the battery harness. Make sure
that you position it in the exact same place during assembly.
10. Disconnect one of the batteries from the battery
harness and the circuit breaker and remove it.
11. Disconnect the other battery from the battery harness
and the circuit breaker and remove it.
12. Place a new battery into the bottom half of the
battery pack. Make sure that the terminals are
facing as shown. See figure 33.
13. Connect the battery harness and the circuit
breaker to that battery.
14. Place the second new battery into the bottom half of
the battery pack with the terminals facing as shown.
See gure 33.
Prevent electrical shock!
Make sure that you connect the batteries
according to the battery diagram. See gure 34.
15. Connect the battery harness and circuit
breaker to that battery.
16. Place the top half of the battery pack onto the bottom.
17. Turn the battery pack over.
18. Reinstall the eight (8) screws that fasten the
top and bottom halves of the battery pack together.
19. Tighten the circuit breaker button cover.
20. Reinstall the battery pack.
Circuit Breaker
Figure 32. Battery Pack (bottom side)
Terminals
Battery Box Top
Figure 33. Inside Battery Pack
BATTERY
BATTERY
FUSE
RED
Figure 34. Battery Diagram
Buzzaround XL_SG_REVA_100711
Circuit Breaker Button Cover
Terminals
Fuse
INSIDE BATTERY PACK
BLACK
BATTERY
HARNESS
CHARGER
HARNESS
20

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Buzzaround xl gb116

Table of Contents