Golden Technologies Buzzaround XL GB146 Service Manual page 43

BEEP CODE #8 - MOTOR VOLTAGE FAULT (OPEN/SHORTED)
Remove the seat.
50 ohms but not shorted?
NOTE: Can be as low as 0.2 ohms.
Replace the
controller.
Open?
Remove the
battery pack.
Yes
Replace as necessary.
Remove the battery
pack.
Disconnect the front
intermediate motor
harness (8c and 8d)
from the controller.
Measure resistance across
the front intermediate
motor harness 8c and 8d.
See figure 28.
Make sure that the pins are
seated properly on 9b.
Check the continuity
between 8c/8d and 9b.
Separate the
drivetrain from
the front frame.
Inspect the front and rear
intermediate motor harness
connectors. Are they discolored
or corroded?
Remove the four screws that
fasten the controller cover to the
underside of the scooter frame.
Out of that range?
Unplug the motor/brake
assembly from the rear
intermediate motor
harness.
10 ohms or less but not shorted?
No
Buzzaround XL_SG_REVA_100711
42